Install Bambu Poop Conveyor
Use this installer for a new ESP32 or recovery. Connect the ESP32 to this computer with a data-capable USB cable and keep this page open until setup finishes.
Already running the conveyor? Install v1.5.0 from the device’s Update tab to preserve its saved settings. A clean USB installation can erase Wi-Fi, printer, and trigger configuration.
1Connect and installThe browser flashes the complete v1.5.0 firmware image.
2Join your Wi-FiEnter network details when the installer asks—there is normally no need to leave this page.
3Open and verifyThe installer returns the ESP32’s local control-center address when it is online.
Need to return to the previous v1.4.2 release?
v1.4.2 is the last known-good release before v1.5.0. These are the original, checksum-verified files—not rebuilt replacements.
Choose the correct method. OTA rollback from a working device preserves its stored configuration. USB recovery performs a clean installation and can erase Wi-Fi, printer, and trigger settings.
Working device: OTA rollback
Download the application-only file, open the ESP32’s Update tab, and use Upload your own file.
Download v1.4.2 OTA rollback View checksumsUSB recovery
Use this if the device is unreachable or you want a clean v1.4.2 installation.
After flashing: Wi-Fi setup
The installer normally asks for Wi-Fi details and returns the device address automatically. If that step is skipped or does not appear:
- Wait up to one minute after the ESP32 restarts. If the setup network does not appear, power-cycle the ESP32 once.
- Connect your computer or phone to:
Wi-Fi network: BambuConveyor
Wi-Fi password: 12345678
Wi-Fi password: 12345678
- If the configuration page does not open automatically, visit 192.168.4.1.
- Enter the Wi-Fi and Bambu printer settings, then select Save settings.
- Allow the ESP32 to reboot and reconnect to the configured Wi-Fi network.
This HTTPS page is required for USB installation. The finished ESP32 control center stays private on your local network and uses local HTTP.